Yums Dyno Day Today **Result's page 2 & 3**
#286
10K+ Poster!!
iTrader: (1)
Join Date: Jul 2003
Location: Co Durham
Posts: 14,796
Likes: 0
Received 0 Likes
on
0 Posts
Everything is going well as far as I can see.
We got Dave, Miller, Jb & SiB on the case ! Poor Si just called in as he was in the area and he has been roped in !
And me and Becky are sat enjoying the sun !
We got Dave, Miller, Jb & SiB on the case ! Poor Si just called in as he was in the area and he has been roped in !
And me and Becky are sat enjoying the sun !
#288
Advanced PassionFord User
Thread Starter
iTrader: (4)
Join Date: Sep 2008
Location: Sutton
Posts: 2,250
Likes: 0
Received 0 Likes
on
0 Posts
What a busy day
A big big big thanks to Doug, JB and Si also to Helen and Becky
Its all in, just need to sort out all the little bits hopefully get it over to Marks one evening then l can go over next weekend and do some more
Helen will load up some photos
We had to remove one of the fuel rails as it would'nt go it was not a problem last time due ti the second rail not being there
Had a nice BBQ afterwards and a well needed rest
So cheers guys for all your hard work
A big big big thanks to Doug, JB and Si also to Helen and Becky
Its all in, just need to sort out all the little bits hopefully get it over to Marks one evening then l can go over next weekend and do some more
Helen will load up some photos
We had to remove one of the fuel rails as it would'nt go it was not a problem last time due ti the second rail not being there
Had a nice BBQ afterwards and a well needed rest
So cheers guys for all your hard work
#289
10K+ Poster!!
iTrader: (1)
Join Date: Jul 2003
Location: Co Durham
Posts: 14,796
Likes: 0
Received 0 Likes
on
0 Posts
Kelv - Wondered where you had got to lol Always good to get an early finish !
Couple of photo's
Chip - See I told you Si B was under the car
Huge thank you to JB, Miller & Becky & Si B for all their help today, so glad it's all back in the car now!
Si - Thank you for the spin out in the new Evo, love it ! My turn to drive next time
Couple of photo's
Chip - See I told you Si B was under the car
Huge thank you to JB, Miller & Becky & Si B for all their help today, so glad it's all back in the car now!
Si - Thank you for the spin out in the new Evo, love it ! My turn to drive next time
Last edited by Cossie Helen; 26-04-2009 at 09:03 PM.
#296
just finding my feet
a horrible one,,,,, wrong colour,, paint missing off the bonnet, roof and boot,,, chavy brake caliper covers you get on ebay,,,, terrible car,,,,, i offered to swop him my scoobie as he was done over in the deal as hes a nice guy but he wont,,,, i said straight swop too,,, no need to give any extra cash on top but he wouldnt have it
I HATE YOU SI !!!!
#297
Advanced PassionFord User
Thread Starter
iTrader: (4)
Join Date: Sep 2008
Location: Sutton
Posts: 2,250
Likes: 0
Received 0 Likes
on
0 Posts
This is whats left to do
Turbo return pipe to be made
Then bolt up Power stearing pump and fill up
Bolt up Rad, Intercooler and turbo pre rad and fill up with water
Cut down and extend some of the breather pipes
Connect and bolt up and wire CDI unit
Fit external wastegate and the full exhaust
Extend boost control wire and pump up boost valve
Fill up with oil and make sure l get a couple of washers for oil temp sender unit in sump
Connect and bolt up fans and then make sure SM4 controls them
Fit up 2 addition pumps and plum up and wire, fit new fuel filter, also plum up the return and intakes of both fuel rails
Bleed the clutch and make sure l get the spacer back in the clutch peddle
Connect up the speed control sensor and water injection
Wire up the AIM dash and get that working again
Track up the car and then have a MOT and tax
So a fair few bits leaved
Turbo return pipe to be made
Then bolt up Power stearing pump and fill up
Bolt up Rad, Intercooler and turbo pre rad and fill up with water
Cut down and extend some of the breather pipes
Connect and bolt up and wire CDI unit
Fit external wastegate and the full exhaust
Extend boost control wire and pump up boost valve
Fill up with oil and make sure l get a couple of washers for oil temp sender unit in sump
Connect and bolt up fans and then make sure SM4 controls them
Fit up 2 addition pumps and plum up and wire, fit new fuel filter, also plum up the return and intakes of both fuel rails
Bleed the clutch and make sure l get the spacer back in the clutch peddle
Connect up the speed control sensor and water injection
Wire up the AIM dash and get that working again
Track up the car and then have a MOT and tax
So a fair few bits leaved
#298
10K+ Poster!!
iTrader: (1)
Join Date: Jul 2003
Location: Co Durham
Posts: 14,796
Likes: 0
Received 0 Likes
on
0 Posts
a horrible one,,,,, wrong colour,, paint missing off the bonnet, roof and boot,,, chavy brake caliper covers you get on ebay,,,, terrible car,,,,, i offered to swop him my scoobie as he was done over in the deal as hes a nice guy but he wont,,,, i said straight swop too,,, no need to give any extra cash on top but he wouldnt have it
I HATE YOU SI !!!!
I HATE YOU SI !!!!
#299
just finding my feet
This is whats left to do
Turbo return pipe to be made
Then bolt up Power stearing pump and fill up
Bolt up Rad, Intercooler and turbo pre rad and fill up with water
Cut down and extend some of the breather pipes
Connect and bolt up and wire CDI unit
Fit external wastegate and the full exhaust
Extend boost control wire and pump up boost valve
Fill up with oil and make sure l get a couple of washers for oil temp sender unit in sump
Connect and bolt up fans and then make sure SM4 controls them
Fit up 2 addition pumps and plum up and wire, fit new fuel filter, also plum up the return and intakes of both fuel rails
Bleed the clutch and make sure l get the spacer back in the clutch peddle
Connect up the speed control sensor and water injection
Wire up the AIM dash and get that working again
Track up the car and then have a MOT and tax
So a fair few bits leaved
Turbo return pipe to be made
Then bolt up Power stearing pump and fill up
Bolt up Rad, Intercooler and turbo pre rad and fill up with water
Cut down and extend some of the breather pipes
Connect and bolt up and wire CDI unit
Fit external wastegate and the full exhaust
Extend boost control wire and pump up boost valve
Fill up with oil and make sure l get a couple of washers for oil temp sender unit in sump
Connect and bolt up fans and then make sure SM4 controls them
Fit up 2 addition pumps and plum up and wire, fit new fuel filter, also plum up the return and intakes of both fuel rails
Bleed the clutch and make sure l get the spacer back in the clutch peddle
Connect up the speed control sensor and water injection
Wire up the AIM dash and get that working again
Track up the car and then have a MOT and tax
So a fair few bits leaved
i got the tracking to be done on mine, mot soon and,,,, i must get a number plate made up
i have every faith you will get it done,,,,, is that a cold i hear you getting,,,, wanna be carefull that dont get worse and you have to TAKE A FEW DAYS OFF SICK !! mate
#303
just finding my feet