Exhaust Stud Torque to Cyl head??????
#1
Rubber Rhino Crew
Thread Starter
iTrader: (1)
Join Date: Dec 2005
Location: Birmingham
Posts: 2,157
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Anyone know the ford recommended torque value for the exhaust studs to the cylinder head?
I have found the value of 19-23 for the nuts but can't find a value for the studs.
Cheers
Dan
I have found the value of 19-23 for the nuts but can't find a value for the studs.
Cheers
Dan
#2
10K+ Poster!!
![](https://passionford.com/forum/images/pf_gold_member.png)
iTrader: (9)
Join Date: May 2004
Location: birmingham west mids
Posts: 11,919
Likes: 0
Received 11 Likes
on
9 Posts
![Default](https://passionford.com/forum/images/icons/icon1.gif)
It is fuck all mate, about 3 Lbs/ft if that. Basically just nip them in. DON'T overtorque them and shear it, as it will mean you have to take the head off to get it removed as the access is crap ![Red Faced](https://passionford.com/forum/images/smilies/icon_redface.gif)
(Speaking from experience ![Red Faced](https://passionford.com/forum/images/smilies/icon_redface.gif)
).. If you can wait till' wednesday I will get the figure out of the Cossie workshop manual for you.
![Red Faced](https://passionford.com/forum/images/smilies/icon_redface.gif)
![Surprised](https://passionford.com/forum/images/smilies/bigcry.gif)
![Red Faced](https://passionford.com/forum/images/smilies/icon_redface.gif)
![Wall](https://passionford.com/forum/images/smilies/wall.gif)
Last edited by RWD_cossie_wil; 08-03-2009 at 06:08 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Tank Mike
Ford Focus ST Parts for Sale
3
18-05-2016 09:38 PM
Si B
General Car Related Discussion.
2
12-09-2015 06:49 AM