Tank Mike

Who was it who made the kit and how much was it. i can't remeber.


thanks

mike

dave cos4x4

iTrader: (5)

see Martin @ Reyland for this.

Martin-Hadland

iTrader: (2)

£300 pus vat ..

NEEDFORSPEED

or make one

tabetha

I used a bracket kit from Magnum Engineering for the master cylinder position and a Leyland Sherpa master cylinder, with reservoir on engine bulkhead.
tabetha

Jay,

iTrader: (4)

interesting mate

tabetha

This wasn't for a cossie but a V8 xr4i, but same thing this end, luckily the rover box was already hydraulic, but otherwise would have tigged a lump on side of belhousing to operate slave cylinder.
tabetha

Jay,

iTrader: (4)

that isnt a hard job tho tabetha oh good to see you back by the way

andrewg

wilwood master cylinder with integral resivoir £30 and a ap land rover slave cylinder £40 and a bit of jigerypokery

Jay,

iTrader: (4)

it gets better

ian sibbert

We have done this sort of thing loads of times on RWD conversions.....series 2 landrover 7/8 slave cylinder....with a 7/8" master cylinder.....

Or a flash wilwood master cylinder...



Or you can use one of these....



Pull type which replaces a cable....nice...