Under piston oil spray jets for Zetec's....
#7
PassionFord Post Whore!!
Thread Starter
iTrader: (1)
Join Date: Oct 2005
Location: Liverpool
Posts: 5,016
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by dave cos4x4
Originally Posted by Shorty
Originally Posted by dave cos4x4
would a late cossie one fit Dave.
Jonno, just been on Mountunes site, £200 for a set!
Trending Topics
#20
PassionFord Post Troll
Join Date: May 2003
Location: Rushden, Northants
Posts: 3,307
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by fudgeass
danny, there is basically a hole that goes into a high pressure oil feed, then then a smaller tapped hole to screw a screw in to hold them in place.
the jets themselves have a ball bearing in them to stop the oil returning back into the feed
the jets themselves have a ball bearing in them to stop the oil returning back into the feed
#23
Baby Cheesus
iTrader: (4)
Originally Posted by Danny B
Originally Posted by fudgeass
danny, there is basically a hole that goes into a high pressure oil feed, then then a smaller tapped hole to screw a screw in to hold them in place.
the jets themselves have a ball bearing in them to stop the oil returning back into the feed
the jets themselves have a ball bearing in them to stop the oil returning back into the feed
my pistons slightly touched the jets, so i had to very slightly bend them round a bit more, they are not dead straight like i have drawn, the ends have a slight curve to them.
#24
PassionFord Post Troll
Join Date: May 2003
Location: Rushden, Northants
Posts: 3,307
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Franco
Originally Posted by StickerPaul
What you up too...........
#25
PassionFord Post Troll
iTrader: (8)
The late 4x4 cosworth pistons have a slight notch in the skirt to avoid contact with the jet - maybe the same could be done to the pistons in the other engines
Question is - can these zetec jets be retro fitted to a YB block that does not have jets fitted if the existing oilways were tapped into, as the cosworth ones are very pricey
Question is - can these zetec jets be retro fitted to a YB block that does not have jets fitted if the existing oilways were tapped into, as the cosworth ones are very pricey
#29
Regular Contributor
Join Date: May 2004
Location: here and there
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
yes i is not uncommon for them to get snap'd off on the zetec engines and end up laying about in the bottom of the sump.
that is why our pistons have been machined with a amall notch to clear them. reliability
that is why our pistons have been machined with a amall notch to clear them. reliability
Thread
Thread Starter
Forum
Replies
Last Post
grishenko45
Technical help Q & A
0
09-09-2015 12:58 PM