As above really i have a water temp gauge to install but not sure wheres the best place to put the sender on a Saph?

I had thought about putting it in the pipe where my swirl pot is with a connector from tweekies. Then i wondered if i could use the hole where the standard temp sensor is by using a T piece if thats possible. Or if anyones got a better idea where to put it that would be great.

 

Depending on the the thread type, you can replace the existing sensor with the new one....

 

And just get rid of the standard gauge?

 

Yes, why do you want two? The Ford one is about as accurate as sticking your finger in the water - you know it's fucking hot, but have no idea HOW hot .

 

mine runs in the block by the turbo,between 3and 4 cylinders
theres a plug there to take out,also is this supposed to be hottest part of the engine?

 

Cheers Mike and Besky will get it sorted this week.

 

Yep you can help me with mine then

 

No problems bud.

I might have to pick you bufty brain on how you polished up compressor wheel again. Well got to do something while i am off for almost 4 weeks lol.