Twellsie

iTrader: (1)

On returning from the Isle of wight RSOC day i got just out of Portsmouth and the Cossie decided to blow a water hose, after being charged £197 and it taking 5 and a half hours to get home courtesy of the AA of which the ripped the valence off and broke one of the bumper mounts for free!
next day got a replacements pipe and fitted it,
here comes the next problem, decidided t would probably be a good idea to change the oil as the temperature gauge went through the roof,jacked the car up to hear a strange tearing noise, stood back just in time to watch the jack snap in half and slam into the front wing . finally got the car jacked up and set about removing the sump plug, which of course due to my current lucky streak has decided to strip the head, i have tried everything i can think of to remove it but without and luck,
Any one got any good ideas as i am getting close to the point of setting fire to the bloody thing.

thanks in advance
Rich

ECU Monitor Enthusiast

iTrader: (1)

Weld a nut or bolt to it

Lloyd

depending on how bad its rounded off,try a 1/2 inch ring spanner,they are slightly smaller than 13mm.or bring it round to my house and i will have a go at getting it off for ya.

Twellsie

iTrader: (1)

it is really rounded, where is your house?

ballin

iTrader: (1)

have you tried smacking it round with a chisel?

Twellsie

iTrader: (1)

the head is to small to be able to get any rotation

Lloyd

pm on its way.