Brake Pipe Bending Tool
Thread Starter
I've found that life I needed.. It's HERE!!
iTrader: (20)
Joined: Dec 2004
Posts: 1,454
Likes: 1
From: West Sussex
Brake Pipe Bending Tool
Does anyone know of a small radius pipe bender to replicate the bends of original brake pipes?
I've got one of the normal ones a bit like this... http://cgi.ebay.co.uk/3IN1-COPPER-PI...item414d1795c0
...but when doing say a 90deg bend the actual radius is bigger than the std pipe. It's not a major problem it'd just be nice to make them spot on!
I've got one of the normal ones a bit like this... http://cgi.ebay.co.uk/3IN1-COPPER-PI...item414d1795c0
...but when doing say a 90deg bend the actual radius is bigger than the std pipe. It's not a major problem it'd just be nice to make them spot on!
cossie fan (unluckerly)
Joined: Nov 2009
Posts: 9,798
Likes: 435
From: hampshire
the one u show is good for larger bends but these are good for smaller bends http://cgi.ebay.co.uk/Pipe-Bending-P...item45ed9cdaa9
Thread Starter
I've found that life I needed.. It's HERE!!
iTrader: (20)
Joined: Dec 2004
Posts: 1,454
Likes: 1
From: West Sussex
Thanks for that
Also found this as well (not sure how they compare?)... http://www.demon-tweeks.co.uk/produc...code=S/C000160
...no idea why i didn't come across those before!
Also found this as well (not sure how they compare?)... http://www.demon-tweeks.co.uk/produc...code=S/C000160
...no idea why i didn't come across those before!
cossie fan (unluckerly)
Joined: Nov 2009
Posts: 9,798
Likes: 435
From: hampshire
never seen one of them should do the job if they say it will have used the type u have and the one i showed that one on ebay is a good little tool easy to use to with copper pipe anyway harder with steel
Thread
Thread Starter
Forum
Replies
Last Post
