I'm selling my carlooms uk braided engine loom *SOLD*
If this sells I will also sell my secs monitor but the loom needs to sell first or together.

this loom with fit a 2wd or 4wd cosworth.
My loom has every extra built into it, twin ignition amps which are included, secs monitor lead, lamba sensor lead, and coil pack lead.
There's also 2 crank sensors built into it and are controlled via a switch, I'm sure the spare sensor it wired up for a 36-1 or cam sensor pulley but I've never used it. i'm just using it how a standard 2wd and 4x4 set up is using the dizzy
I also bought extensions for icv and tps due to buying a hart plenum which cost me £15 each. These extensions are included and are braided and made by Ryan.
Switchs for anti lag and launch control will be included.
A standard loom costs £400 and mine was over £500, plus twin amp brackets cost £30 then what ever the amps cost to run wasted spark.

Loom + extentions, twin amps and bracket to mount them. £350
Monitor is £220

Buy both for £550 delivered

I will add pictures ASAP.

 

Now that sounds seriously sexy...

 

Get it bought lol

 

updated advert to say what you get with loom.
loom
extensions
2x amps
twin amp bracket to mount them
£350

 

Somebody buy the loom

Steve

 

Come on tempt me with some pics. Also the secs monitor

 

What are the benefits of this loom?

 

I'll sort some out tomorrow mate

 

The standard loom is now 20+ years old which can start to break down and cause you problems.
They look much neater in your engine bay and are not as bulky as a standard loom.
You can run wasted spark and closed loop fueling.

 

hi, the lomm is lhd or rhd?

 

It's a rhd car but I can't see there been any different because everything is still on the same side of the engine if it's left or right hand drive.

 

can you give me a call on 07815 879956 to sort out secs monitor


Eugene

 

I do have someone wanting the monitor already mate but the loom needs to sell first or both sell together.

 

ECU is on opposite side mate. Yours is on left siede, and LHD cars have it on right side. So LHD loom could be a bit longer probably.

maciek

 

here some pictures

you can have the loom as in the picture or could fit it under the rail so it can't be seen.




everything all marked up so you cant go wrong in fitting it

 

here's some pictures of the monitor, it has other screen modes but just took a few.

 

hi,is the loom from the ecu or from under the bonnet

 

the loom feeds through the bulk head and plugs into the ecu inside the car

 

Steve

 

have you got the water injection loom for the SECS monitor?

 

Were do you connect the white 6 pins connector too???