4x4 Cosworth parts
#1
Too many posts.. I need a life!!
Thread Starter
iTrader: (16)
Join Date: Jan 2008
Location: West Sussex
Posts: 882
Likes: 0
Received 0 Likes
on
0 Posts
4x4 Cosworth parts
I broke a saph 4wd a while ago and still have bits for it laying around. If they dont sell I'm not too bothered as I'll keep for spares but as I'm rebuilding a YB engine, the money would be helpful
All parts can be posted at an extra cost. You're more than welcome to pick things up from me. Pics on request.
Please PM me as its easier to keep track of who wants what. 1st come first served.
Also open to swaps as I have a lot of 2WD parts, please see the swap section,WHY?.
Cheers.
2WD Thermostat housing - £20
2WD Throttle position sensor - £20
2WD Water Pump (possibly, not sure if 4WD) - £40
2WD Inlet Cover in silver
Late spec Black Dash ( got a guage holder stuck to the top vents)- £60
Rear Prop - £50
Rear diff - £100
Rear Bumper (cracked) - £30
Headlights - £35
Rear Lights with plate surround (2 threads broken on surround) - £30
Silver Grill - £20
De-locked Drivers door - £25
De-locked Passenger Door - £25
Rear doors - £15ea
Bonnet with vents and vent covers (little dent but hard to see) - £100
2x Front Elec Window motors - £20
Full Car Loom (minus fuse box)- £50
Standard Rad - £40
Set of Seat belts - £40
Front ARB (poss Polybushed, Purple?) - £25
Rear ARB - £20
Boot Carpet - £20
Rear Driveshafts - £40
Rear Arms - £30ea
4x Internal Rubber window seals - £40
Heater matrix - £25
Wiper motor - £20
Bonnet sound deadening - £30
ABS ECU - £40
ABS Distribution block - £20
Roof gutter Plastics - £20
4x Windows V.G.C - £40
'C' pillar exterior trims - £20
There maybe more but I'll list it as I go.
All parts can be posted at an extra cost. You're more than welcome to pick things up from me. Pics on request.
Please PM me as its easier to keep track of who wants what. 1st come first served.
Also open to swaps as I have a lot of 2WD parts, please see the swap section,WHY?.
Cheers.
2WD Thermostat housing - £20
2WD Throttle position sensor - £20
2WD Water Pump (possibly, not sure if 4WD) - £40
2WD Inlet Cover in silver
Late spec Black Dash ( got a guage holder stuck to the top vents)- £60
Rear Prop - £50
Rear diff - £100
Rear Bumper (cracked) - £30
Headlights - £35
Rear Lights with plate surround (2 threads broken on surround) - £30
Silver Grill - £20
De-locked Drivers door - £25
De-locked Passenger Door - £25
Rear doors - £15ea
Bonnet with vents and vent covers (little dent but hard to see) - £100
2x Front Elec Window motors - £20
Full Car Loom (minus fuse box)- £50
Standard Rad - £40
Set of Seat belts - £40
Front ARB (poss Polybushed, Purple?) - £25
Rear ARB - £20
Boot Carpet - £20
Rear Driveshafts - £40
Rear Arms - £30ea
4x Internal Rubber window seals - £40
Heater matrix - £25
Wiper motor - £20
Bonnet sound deadening - £30
ABS ECU - £40
ABS Distribution block - £20
Roof gutter Plastics - £20
4x Windows V.G.C - £40
'C' pillar exterior trims - £20
There maybe more but I'll list it as I go.
Last edited by joe s; 12-12-2009 at 07:04 AM.
Trending Topics
#11
PassionFord Post Whore!!
Have you got a boot release cable and a boot lock barrel???
#14
Wahay!! I've lost my Virginity!!
Join Date: Jun 2009
Location: Crewe
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Looking for the following parts for a 1990 Sapphire RS Cosworth 4x4:
- Gearknob to suit leather interior (pull off/push on)
- LH + RH seatbelt retractor foam NVH housings/pockets
- LH C-pillar fir tree clips
- LH + RH anti-roll bar mounting brackets (and bushes?)
- 2x front damper to hub bolts
- 2x front lower track control arm to hub nut+bolts
- LH + RH front standard damper top spring locator cones
- Genuine Ford leather gearstick gaiter
- 1x engine compartment cross car bulkhead top seal
All parts required in good condition.
Regards,
Alex
- Gearknob to suit leather interior (pull off/push on)
- LH + RH seatbelt retractor foam NVH housings/pockets
- LH C-pillar fir tree clips
- LH + RH anti-roll bar mounting brackets (and bushes?)
- 2x front damper to hub bolts
- 2x front lower track control arm to hub nut+bolts
- LH + RH front standard damper top spring locator cones
- Genuine Ford leather gearstick gaiter
- 1x engine compartment cross car bulkhead top seal
All parts required in good condition.
Regards,
Alex
#15
Too many posts.. I need a life!!
Thread Starter
iTrader: (16)
Join Date: Jan 2008
Location: West Sussex
Posts: 882
Likes: 0
Received 0 Likes
on
0 Posts
Looking for the following parts for a 1990 Sapphire RS Cosworth 4x4:
- Gearknob to suit leather interior (pull off/push on)
- LH + RH seatbelt retractor foam NVH housings/pockets
- LH C-pillar fir tree clips
- LH + RH anti-roll bar mounting brackets (and bushes?)
- 2x front damper to hub bolts
- 2x front lower track control arm to hub nut+bolts
- LH + RH front standard damper top spring locator cones
- Genuine Ford leather gearstick gaiter
- 1x engine compartment cross car bulkhead top seal
All parts required in good condition.
Regards,
Alex
- Gearknob to suit leather interior (pull off/push on)
- LH + RH seatbelt retractor foam NVH housings/pockets
- LH C-pillar fir tree clips
- LH + RH anti-roll bar mounting brackets (and bushes?)
- 2x front damper to hub bolts
- 2x front lower track control arm to hub nut+bolts
- LH + RH front standard damper top spring locator cones
- Genuine Ford leather gearstick gaiter
- 1x engine compartment cross car bulkhead top seal
All parts required in good condition.
Regards,
Alex
#26
PassionFord Post Whore!!
Do you have the rubber trim around both doors on both sides (not the inside seals) and the trim between the front and back doors?
#27
Too many posts.. I need a life!!
Thread Starter
iTrader: (16)
Join Date: Jan 2008
Location: West Sussex
Posts: 882
Likes: 0
Received 0 Likes
on
0 Posts
I will have to have a look for those mate, I do have a big bag of rubber seals and trims in the lockup. Give me a day or so and I'll get back to you mate.
Thread
Thread Starter
Forum
Replies
Last Post