500+bhp Cosworth engine
#1
Wahay!! I've lost my Virginity!!
Thread Starter
Join Date: Jul 2007
Location: Sussex...
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
500+bhp Cosworth engine
Fully rebuilt low mileage 4x4 sapphire cosworth engine...
200 Block
No wear/lip on the bores at all
Wire rung
Mahle low comp pistons
All standard size GRP A bearings
ARP rod bolts
Lightened and balanced crank, rods flywheel etc
High Pressure 4x4 oil pump
2wd sump
This bottom end has covered running in miles and that is it..
Comes with all group a gaskets and a ARP Stud n Nut kit if required..
QEP (http://www.q-e-p.co.uk) Fully rebuilt 4x4 Big Valve Head..
37.5mm inlet valves (Couldn't be much bigger!)
Exh and Inlet ports machined open
Custom Turbo Cosworth Spec CATCAMS (biggest duration tht can be used whilst retaining hydulic lifters) CATCAMS part no. 2330827
New Lifters and all parts for head including double valve springs
CATCAMS Fully adjustable verniers
Powered Coated in black Rocker Cover
This head hasnt been used yet.. and flowed 45% more on the flow bench than a standard head!!
I know how much an engine would cost to build to this spec and with the right turbo and inlet manifold can make 500-550 BHP without running too much boost..
£3000...
200 Block
No wear/lip on the bores at all
Wire rung
Mahle low comp pistons
All standard size GRP A bearings
ARP rod bolts
Lightened and balanced crank, rods flywheel etc
High Pressure 4x4 oil pump
2wd sump
This bottom end has covered running in miles and that is it..
Comes with all group a gaskets and a ARP Stud n Nut kit if required..
QEP (http://www.q-e-p.co.uk) Fully rebuilt 4x4 Big Valve Head..
37.5mm inlet valves (Couldn't be much bigger!)
Exh and Inlet ports machined open
Custom Turbo Cosworth Spec CATCAMS (biggest duration tht can be used whilst retaining hydulic lifters) CATCAMS part no. 2330827
New Lifters and all parts for head including double valve springs
CATCAMS Fully adjustable verniers
Powered Coated in black Rocker Cover
This head hasnt been used yet.. and flowed 45% more on the flow bench than a standard head!!
I know how much an engine would cost to build to this spec and with the right turbo and inlet manifold can make 500-550 BHP without running too much boost..
£3000...
Trending Topics
#10
#18
Wahay!! I've lost my Virginity!!
Thread Starter
Join Date: Jul 2007
Location: Sussex...
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
big_Rad
General Car Related Discussion.
8
15-09-2017 09:36 AM
wheelwizardrefurbs
Technical help Q & A
10
04-08-2015 06:23 PM