jeo022

Am after a bit of advice, currently have an xr3i running an EFi engine but am thinking of an engine conversion, any ideas what engine i could put in it without too much work? also what kind of figure would i be looking at for a fairly decent engine? Not looking to spend a fortune.
Cheers for your time,
joe

tabetha

Easiest for the money has to be ZETEC ?, pick up a good lump for free as a scrapper car ?
tabetha

jeo022

cheers, what are they like to fit? will they drop straight in?

djmillsy

sohlud drop straght in mate of its a 2 litre you need a few other pieces

jeo022

if i were to put a 2l in what other bits would be needed? it is a mk4 xr3i not mk5 does that make any difference?
Cheers
joe

djmillsy

youd need the sump pan and the water pump off a 1.6 motor and the ecu of a mk5 xr3i 130