Tigercatkid

Hi,

just wondering if anyone has the timing and valve lift specs for the stock ST170 camshafts? I'm trying to calculate whether I will need to have my pistons pocketed when changing over to a higher-lift racing cam...

Cheers...

pyle

O.E.M. Cam
duration 277 / 265
duration 230 / 220
maximum lift 10.95 / 9.85mm
lift at TDC 0.25 / 1.05mm

Not sure if it's correct, its from CFM's site.

Tigercatkid

Thanks - thats very helpful

STeve

iTrader: (11)

had these cams recently installed along with a few other mods and was very happy

http://www.burtonpower.com/kent-cams...kcst1703x.html

Tigercatkid

Hi, thanks for the reccommend... I was looking at the Piper270 cams they have slightly lower lift.

Did you have to pocket the piston crowns, or was there sufficient clearance ?

any idea of the power / torque gains ??

STeve

iTrader: (11)

dyno'd at 205 but thats with combination of other mods too, no piston work needed but I did buy entire kit inc followers etc tuner said the cams were prob worth around 12 ish extra hp

pyle

Those are huuge cams. These are for 280+ cams!!