MF2
Thread Starter
Wahay!! I've lost my Virginity!!
Joined: Mar 2010
Posts: 50
Likes: 0
From: Stavanger, Norway
MF2
Hi guys!
Just got my MF2 in the mail. Can anyone give me a good tip on how to get it to turn on at 10psi? or is this standard so just plug and play?
Thanks
- Sondre
Just got my MF2 in the mail. Can anyone give me a good tip on how to get it to turn on at 10psi? or is this standard so just plug and play?
Thanks
- Sondre
..BS Motorsport..
Joined: May 2003
Posts: 4,118
Likes: 10
From: Ponte-carlo
Are you using the pressure switch or a three bar map sensor? AFAIK using a foot pump to provide air pressure to the sensor then dial it in on the mf2 so that when your putting 10psi down the line it picks up. Certainly not a plug and play device though, needs setting up properly at all RPM sites.
Thread Starter
Wahay!! I've lost my Virginity!!
Joined: Mar 2010
Posts: 50
Likes: 0
From: Stavanger, Norway
Are you using the pressure switch or a three bar map sensor? AFAIK using a foot pump to provide air pressure to the sensor then dial it in on the mf2 so that when your putting 10psi down the line it picks up. Certainly not a plug and play device though, needs setting up properly at all RPM sites.
Thread
Thread Starter
Forum
Replies
Last Post