Turbo Lekker

Folks,

I recently got me a Series 1 RST half finished project. Now it's been a while since i had an RST since some lively fekker stole my last 250BHP version. arrrgh.
Anyways i have a new lovely condition one but it's EFI not MFI and i'm a little lost.

What would be handy is a diagram of the Fiesta RST engine such that i can check out the plumbing and components. as ever takign on someones old half done project is a pain and EFI is new to me so i need help please.

above is priority but also, any help ont he below would be greatly appreciated:

1. diodes required and diagram to make the existing rev counter work off the coil pack from EFI
2. any ideas on accelerator cables as the S1 does not match the FRST throttle body
3. what the hell does the map sensor supressor look like, i under stnd i need one on OFAB but i have no idea which of many bits it could be in my box of bast@rds
4. what relay should i use for fuel pump and injection
5. how do i plump and connect FRST ACT (air charge temperature) sensor located on the inlet runner

Thanks

sorry for being a new lemon, just keen to get this gem of a S1 up and running