I drove my car today properly for the first time after an extensive rebuild over winter. I will attach photos soon. Anyway the car drove brilliantly but I wondered what psi boost is ok to run. The engine spec is stage III with pectel management, rs 5oo intercooler water injection etc etc.

Thanks......

 

depends on the chip have you rebuiult enine?

Are you asking what boost for running in??

If so just loop the actuator to the compressor housing for 500 miles then connect it all back up as per normal and run 10 for 250 the a little more then setup

 

i wouldn run any boost until i had it checked by a pro..

alotof things can change with a rebuild.

 

run of the mill stg 3 boost is around 22-24 psi

 

what dose this do if you have theactator looped over to the compresser????

 

JUst gives minimal boost

 

Also, you need an accurate boost guage, not the "finger in the air" standard item .