Hi

I was wondering does anyone know how tight to tighten the nuts on the rocker type things which go from the hydralic tappets and the valves?

 

10 to 15nm or 7 to 11lbft mate

 

30nm mate.

 

i thought they were 18Lb/ft

 

It's definately round about the 30nm mark, 27-29 i seem to remember it stating in the manual but 30 is the lowest my torque wrench goes to lol.
Certainly wants to be more than 10nm though......that's barely nipped up!

 

and put some bearing grease on the gasketcork

 

Haynes cvh engine manual says 25-29nm! Sorry bout the miss information

 

F.T.

 

Thanks guys