Breaking Nissan skyline R32 Pro spec drift car in Ireland
Right lads the car is not selling as whole so I am going to have to break it
Spec:
RB20DET,
HKS GT2535 pro turbo,
GTR injectors with brand new resistor pack,
MHG,
Apexi induction kit,
FMIC,
stainless elbow and downpipe,
full custom 3 inch system,
GTR fuel pump,
FSE adjustable pressure reglator.
Transmission;
Exeedy paddle clutch,
4.1 welded diff (fitted)
4.3 welded diff (spare)
Chassis;
Tein tension rods,
Tein tie rods and ends (modded for even more lock)
DW adjustable bottom arms,
adjustable front upper camber arms,
Tein super drift coilovers,
modded crossmember to move rack foward (not fitted yet),
all adjustable arms in back axle,
DW hicas lockout bar,
DW solid subframe bushes,
DW solid steering bush,
stock brakes all round with good discs and pads,
17 inch Enkei Tarmac evo rims (v.expensive),
235/40/17 Toyo T1-R front,
235/40/17 federal 595 rears.
Interior;
stripped,
full pro spec cage with door bars,
drivers bucket seat and harness,
hydralic handbrake,
boost gague,
battery cut-off.
Exterior,
Gtr replica front bumper,
Gtr skirts and rear spats,
Gtr N1 headlamps,
clear indicators,
cutom widened front wings,
+40mm rear arches.
Very clean R32 shell with weld in cage that has been cleared and is on irish reg.
There is probably more bits and pieces I have forgotten but will put them up as I remeber them.
Also if anyone has contacted me about parts before please contact me again so I can be clear.
All parts are first come first served, first person with the money gets the parts.
Spec:
RB20DET,
HKS GT2535 pro turbo,
GTR injectors with brand new resistor pack,
MHG,
Apexi induction kit,
FMIC,
stainless elbow and downpipe,
full custom 3 inch system,
GTR fuel pump,
FSE adjustable pressure reglator.
Transmission;
Exeedy paddle clutch,
4.1 welded diff (fitted)
4.3 welded diff (spare)
Chassis;
Tein tension rods,
Tein tie rods and ends (modded for even more lock)
DW adjustable bottom arms,
adjustable front upper camber arms,
Tein super drift coilovers,
modded crossmember to move rack foward (not fitted yet),
all adjustable arms in back axle,
DW hicas lockout bar,
DW solid subframe bushes,
DW solid steering bush,
stock brakes all round with good discs and pads,
17 inch Enkei Tarmac evo rims (v.expensive),
235/40/17 Toyo T1-R front,
235/40/17 federal 595 rears.
Interior;
stripped,
full pro spec cage with door bars,
drivers bucket seat and harness,
hydralic handbrake,
boost gague,
battery cut-off.
Exterior,
Gtr replica front bumper,
Gtr skirts and rear spats,
Gtr N1 headlamps,
clear indicators,
cutom widened front wings,
+40mm rear arches.
Very clean R32 shell with weld in cage that has been cleared and is on irish reg.
There is probably more bits and pieces I have forgotten but will put them up as I remeber them.
Also if anyone has contacted me about parts before please contact me again so I can be clear.
All parts are first come first served, first person with the money gets the parts.
Thread
Thread Starter
Forum
Replies
Last Post
JoeyBoyden
Restorations, Rebuilds & Projects.
26
Jan 4, 2024 02:36 PM




