Finished a customers car a couple of weeks ago, his done over 300 miles now so thought it was about time i showed you fellow Mk3 owners

Any comments welcomed good or bad as its all constructive.





Spec:-

1600cvh ERST Bottom End
Rebuilt EFi head.
CVH35 Kent Cam
Antipump lifters
Adjustable pulley
4x4 Hybrid T3 with 0.48 housing
GRS S1 Intercooler
Mongoose zorst
Bailey oil breather
New S2 RAD
-31 Actuator
Samco's
Alloy Header Tank
Bailey water swirl pot

Weber Management L8 with Pectel Board
3 Bar map sensor
Yellow Injectors
4x4 Fuel Reg
4x4 Ignition amp
Group A coil
909 Leads
C59 plugs
2wd Loom
Efi inlet reworked
2wd Throttle body
Festo air lines

Standard 16i Roll bar
Standard Bilstien suspension
4x4 Cosworth Calipers
2wd Disks
Braided Lines

Standard 16i 5speed Gearbox with push down reverse.
AP four paddle clutch
Twin stainless brake support bars


There is loads of one off stuff all over the engine bay, but this can only be seen up close and in person, so if you ever see him at a show or meet etc.. Ask to have a look as the owner is a freindly chap who im sure will be more than happy to show you around his motor

Thanks for looking.

Full project is below:-
http://members.lycos.co.uk/oddkidd/f...?t=55&start=30

 

Very nice like the way the engine bay has been tidied with all the wiring hidden up

 

Love it

 

very nice mate. have you still got your black mk3? that was very clean.

 

Very impressive
Nice to see a modified 16i.

 

Thanks for the kind words

 

smart as a carrot engine bay looks fantastic

 

mint bay.

 

nice

 

great example of a modded 16i wish i had one...

 

looks very tidy, makes my bay look a right mess

 

looks wicked mate
only thing i dont like are the bonnet raisers