I have a Sapphire Cosworth and took out my part of my dash off today. In doing so I had to disconnect my ACT gauge to get to the part I wanted to. Once finished I reconnected the wires to the correct place and all I am getting now is --- (three lines) displaying.

I have double checked the connections to make sure that they havent come loose and they are all connected perfectly.

anyone got any idea ideas of what I could have done??

 

the sensors f-cked.

about £12 for new one off Mike rainbird.

 

Any idea how I could of done this, its just it was working fine before I took the dash off and now nothing.
I just dont want to do the same again and muck up another sensor

 

i'm guessin mate, but thats wot mine done,


sent it back to mike, and he tested and sent me a new sensor.

Pm Mike would be best.

 

Mine is doin the same at the mo, i persumed the wire must have fallen off the back of the guage, i will have to take it out and have a look.

You could check the resistence through the sensor, see if its gone open circuit.

If you PM mike he will be able to tell you what the resistence should be.