just fitted a frst fuel rail and injectors to my zetec, problem is there is no space for the idle control valve, can i put this somewhere else and just blank off the additional holes.
Could i leave it off or will it cause probs,

anyone know????????????

cheers

 

i am at same bit on zt conversion m8 made up plates and stubs should work ok just mount on inner wing ,my girlfriend has 2i16v i disconected iscv and held up revs on throttle body didnt cause any probs so i may try that oc conversion just link up cable to manual choke think it should work

 

you can use a remote mounting block for the ISCV that is used on some EFi CVH cars - connects up with hoses..