*Bri.4.b.Cos*

any one know exactly what is involved in converting a MFi turbo to run Efi turbo. also any one know were to get all the parts from, many thanks Bri.

biggy_j

hi mate there is a guide in this months performance ford.

robert 123

WHAT MONTH MAG???? 08/05? OR 09/05 OR 10/05. I WISH TO DO THE SAME,HAVE ALL THE REQUIRED PARTS AND DONT KNOW WHERE TO START!!!!

GrimmeRS2K

Ecu related MAP sensor. (OFAC ecu will need an OFAC MAP sensor) Fiesta turbo engine, or mixture of adapter plates and a hole drilled for the CPS EFi inlet manifold, throttle body and charge carrier ACT sensor, from the fiesta turbo Throttle body to charge carrier pipe, still available from Ford at the moment! EFi flywheel, Fiesta RS, XR2i, XR3i (EFi) XR3i EFi whole loom XR3i EFi Dash pod XR3i Throttle cable and pedal EDIS Module and coil pack etc from XR3i (or Fiesta RS)

taken from here

http://cruiseblackpool.co.uk/modules...article&sid=15

CarlRsT

You go on cruiseblackpool Easiest option find a rear end write off Frst swap the lump and loom (or get a efi 3i loom) and get a 3i efi acl peddal as said above

Wazzzer

you don't have to get EFi clocks, you can tap into a feed on one of the EDIS module wires to take care of that

once I've finished mine I'm gonna get together with Rab (if he wants to) and do a guide for it

GrimmeRS2K

na, just a google search mate, never heard of the site