Map sensor help
Thread Starter
Regular Contributor
Joined: May 2008
Posts: 346
Likes: 1
Map sensor help
hi everyone I am running a cosworth yb engine on omex 600 management. Looking to run about 400 bhp maybe more in the future. But wanted to know what map sensor I can run on the omex that will be any good ? As genuine 3 bars are getting rare and expensive. Any other good ones out there ? Thanks.
C**t
Joined: Oct 2003
Posts: 7,998
Likes: 269
From: Norn Iron
You should be able to run any sensor with a standalone ecu. Just calibrate it to suit.
Although there are loads of Chinese shit out there. A Genuine GM 3 bar is hard to beat, but most are chinese now.
Should be plenty of Bosch 3.5 or 4 bar sensors knocking about from the diesel world, although some dont go particularly low in the vacuum range.
Or you can go expensive like branded stuff from KA Sensors etc
Or VEMS sell some decent ones at not too bad money
Although there are loads of Chinese shit out there. A Genuine GM 3 bar is hard to beat, but most are chinese now.
Should be plenty of Bosch 3.5 or 4 bar sensors knocking about from the diesel world, although some dont go particularly low in the vacuum range.
Or you can go expensive like branded stuff from KA Sensors etc
Or VEMS sell some decent ones at not too bad money
