advise needed... my 1992 4x4 saph has a slight miss fire when in boost. at around 3500-4000 rpm its hesitates slightly. if you bring the car up to boost gently its happens less. the car is totally standard apart from a 4" scorpion exhaust. Its happens more if the fuel is low(1/4 tank).
so far all ive tried is new plugs. was advised to use 071 plugs gaped at 0.9 to 1.05. these made the car run lumpy so took them out. ive been advised to try new ht leads... Can anyone recommend a brand?
Any other hints/tips welcome

 

Gap the plugs at .65 that should help

 

i'll give that a try

 

Had the same problem and was the plugs, boost was blowing the spark out

 

ok is the rev counter jumping about ?
is the dizzy and phase sense set up properly


On the engine loom are the 3 plug still left on it on the bulkhead above the cam cover ? if so they might need removing check the one nearest the drivers side for corrosion

 

havnt had a chance to check the wiring as yet. looking through the cars history there is invoices for work done on a misfire. interference from ignition was what it was identified as but work was done to put it right... there has been a new rotor and dissy fitted by previous owner

 

gapped the plugs at .65 still not right running lumpy.
checked wiring seems fine!