i want to replace the plasic fuel pipe on my saph that goes from the banjo on the fuel filter to the metal fuel line but how do u connect the new braided hose to the metal fuel line just concerned about it coming off under pressure cheers steve

 

To do it properly you'll have to remove the fuel line and have an an6 fitting welded or brazed onto it.

 

cheers where do i get a an6 fitting from?

 

Or use a compression fitting with an-6 on the end

http://pages.ebay.com/link/?nav=item...d=150672198035

AN -6 (AN6) STRAIGHT Female To 5/16" (8mm) Tube / Pipe / Hardline Adapter BLACK

One of these, I use these from pump to hardline then hard line to fuel rail and regulator .
They are perfect

 

You can get them with male or female an-6 ends

 

http://www.ebay.co.uk/itm/AN-6-AN6-M...item27e633ede0
then of course you'll need a fitting for the end and a fitting and for the fuel filter plus the braided hose itself.

 

nice 1 i will get 1 puchased

 

will putting a 8mm braided hose be ok just sliding on a 8 mm banjo for the filter end

 

Torques on the link above does a fitting to fit the filter.