Help needed Escort RS Turbo - Idle problem
05-06-2011, 09:03 AM
#1
15000
Thread Starter
iTrader: (1)
Join Date: May 2010
Location: bristol
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Help needed Escort RS Turbo - Idle problem
Hi everyone
I've got a problem with my turbo, it's in the garage at the moment but the mechanic can't work out the problem.
Originally my car wouldn't idle, the mechanic thought it was something to do with the fuel system so I have replaced the fuel metering unit. Now it will idle for around 5 mins before cutting out but then won't restart unless you press down on the plunger on the metering unit or wait until the engine gets cold again.
Has anyone got any ideas? I haven't had this problem before, I only use my car in summer, it was fine last year, over the winter I have fitted a Kent Cam and a KN panel filter but I can't see that being the problem......
I've got a problem with my turbo, it's in the garage at the moment but the mechanic can't work out the problem.
Originally my car wouldn't idle, the mechanic thought it was something to do with the fuel system so I have replaced the fuel metering unit. Now it will idle for around 5 mins before cutting out but then won't restart unless you press down on the plunger on the metering unit or wait until the engine gets cold again.
Has anyone got any ideas? I haven't had this problem before, I only use my car in summer, it was fine last year, over the winter I have fitted a Kent Cam and a KN panel filter but I can't see that being the problem......
05-06-2011, 12:37 PM
#2
Regular Contributor
Join Date: May 2011
Location: Eastbourne
Posts: 216
Likes: 0
Received 0 Likes
on
0 Posts
When you fitted the cam was it new? If it was did you carry out the correct bedding in procedure of keeping it at 2500 - 3000 RPM for about 30 mins and not letting it idle? I'm not saying this is the problem just thought i'd say it. What happens if you start it and just keep the throttle at just over idle speed, does it still cut out?
Last edited by ChrisH; 05-06-2011 at 12:39 PM.
09-06-2011, 08:06 PM
#3
15000
Thread Starter
iTrader: (1)
Join Date: May 2010
Location: bristol
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
When you fitted the cam was it new? If it was did you carry out the correct bedding in procedure of keeping it at 2500 - 3000 RPM for about 30 mins and not letting it idle? I'm not saying this is the problem just thought i'd say it. What happens if you start it and just keep the throttle at just over idle speed, does it still cut out?
Thread
Thread Starter
Forum
Replies
Last Post
Zoggon
Ford Sierra/Sapphire/RS500 Cosworth
5
10-08-2015 10:39 AM
