Injector Question...
#1
Too many posts.. I need a life!!
Thread Starter
Injector Question...
Hi all.
I've had my 2.0 blacktop running n/a in my mk4 fiesta for a couple of months now so I'm ready to push on and get the supercharger fitted.
It's running on megasquirt, and I have water Inj to be fitted when the s/c goes on.
Question, I planned to use Nissan 200sx injectors, and the reading I've done says to use the zetec o-rings. However when I tried it they split when pushing the injectors into the zetec rail. Anyone had a similar problem or are we thinking slightly perished o-rings?
Thanks
Matt
I've had my 2.0 blacktop running n/a in my mk4 fiesta for a couple of months now so I'm ready to push on and get the supercharger fitted.
It's running on megasquirt, and I have water Inj to be fitted when the s/c goes on.
Question, I planned to use Nissan 200sx injectors, and the reading I've done says to use the zetec o-rings. However when I tried it they split when pushing the injectors into the zetec rail. Anyone had a similar problem or are we thinking slightly perished o-rings?
Thanks
Matt
#2
20K+ Super Poster.
Did you oil the injector seals ?, if you sprayed WD40 on them this will cause them to dry out and not go in, a little oil and they will simply fall in nearly!!
tabetha
tabetha
#3
Too many posts.. I need a life!!
Thread Starter
Thanks once again Tabetha,
Matt
Thread
Thread Starter
Forum
Replies
Last Post
mk3ste
Restorations, Rebuilds & Projects.
19
17-10-2021 10:09 AM
DixieTheKid
Ford Sierra/Sapphire/RS500 Cosworth
11
06-06-2020 11:20 AM