newbie help with st170
#1
Wahay!! I've lost my Virginity!!
Thread Starter
Join Date: Feb 2011
Location: bedford
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
newbie help with st170
hi all, ive recently purchased a focus st170, after loving it for a week i have a problem, when slowing towards a roundabout a noise suddenly started, its a noise that is loud in the cockpit, it sounds electrical like something come off a runner, but then knocks it dosnt change with the engine rpm,
help to diagnose this is much appreciated thanks
help to diagnose this is much appreciated thanks
#2
PassionFord Post Whore!!
Does it sound like it's coming from behind the dash in the centre?
The controller for the inlet manifold runner control is bolted to the bulkhead and the plastic linkage can break on the manifold where the cable is connected from the controller to the manifold. Pretty cheap fix, is your engine fault light on too?
This is the controller, check that it's not just the plastic linkage broken before replacing the whole thing tho!
http://www.fordpartsuk.com/shop/focu...l_imrc_813.htm
The controller for the inlet manifold runner control is bolted to the bulkhead and the plastic linkage can break on the manifold where the cable is connected from the controller to the manifold. Pretty cheap fix, is your engine fault light on too?
This is the controller, check that it's not just the plastic linkage broken before replacing the whole thing tho!
http://www.fordpartsuk.com/shop/focu...l_imrc_813.htm
Last edited by GVK.; 24-02-2011 at 08:15 PM.
#3
Wahay!! I've lost my Virginity!!
Thread Starter
Join Date: Feb 2011
Location: bedford
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Does it sound like it's coming from behind the dash in the centre?
The controller for the inlet manifold runner control is bolted to the bulkhead and the plastic linkage can break on the manifold where the cable is connected from the controller to the manifold. Pretty cheap fix, is your engine fault light on too?
The controller for the inlet manifold runner control is bolted to the bulkhead and the plastic linkage can break on the manifold where the cable is connected from the controller to the manifold. Pretty cheap fix, is your engine fault light on too?
thanks
Thread
Thread Starter
Forum
Replies
Last Post
Andypandy260
General Car Related Discussion.
1
23-09-2015 10:28 PM