2 bar map sensor??
Thread Starter
Resident Camel Stalker
Joined: Jan 2011
Posts: 544
Likes: 0
From: Blyth, Northumberland
Where is the best place to get one as I think mine is maybe gone after reading symptoms. But where can I get one? Or does anyone local have one I could borrow and try to see if it's any better?
Thanks
Thanks
I've found that life I needed.. It's HERE!!
Joined: Jan 2008
Posts: 1,134
Likes: 25
From: Netherlands
I have never replaced a defective map-sensor on a Cosworth or a Lancia Delta.
That doesn't mean they can't go defective, but chances are it's something different.
What's the problem?
Measure signal voltage from the sensor at key on, engine off.
Measure 5 volt supply.
That doesn't mean they can't go defective, but chances are it's something different.
What's the problem?
Measure signal voltage from the sensor at key on, engine off.
Measure 5 volt supply.
Thread Starter
Resident Camel Stalker
Joined: Jan 2011
Posts: 544
Likes: 0
From: Blyth, Northumberland
Poor low idle, hesitation on acceleration when turbo on boost and poor mpg. Changed lambda as wiring was slightly melted from manifold. Car seems to be overboosting as it stutters only in 3rd, 4th and 5th between 3000 and 4500-5000rpm. I can't see actuator properly as it's under manifold so I ordered a used focus RS one to put in as I think they're the same but a pal said may be map sensor. No boost gauge ATM though so not sure exactly what boost does when it stutters.
I've found that life I needed.. It's HERE!!
iTrader: (1)
Joined: Feb 2008
Posts: 1,274
Likes: 2
From: Leicester
If its a T190 its a 1.8 Zetec running standard internals, uprated valve springs and Pectal T2 engine managment. These very rare T model Focus seem to be playing up allot lately, i have a piston from a T230 sat on my desk next to me as a result of trying to get to the bottom of rough running
Thread
Thread Starter
Forum
Replies
Last Post
mark94
Ford Mondeo Including ST
5
Oct 10, 2023 06:52 PM




