Hello everyone. Have a 98 escort 1.4 without rev counter. Bought a set of dials with rev counter and was told to wire it from pin 8 on blue plug to pin 4 on ecu. Done this but nothing. Am i doing it right for a 1.4? Any help gratefully received. Thanks.

 

I may be worng here but if you run a wire from the rev clock to the nagtive on the coil it should work.Its old school.

 

Not certain but would have thought that a 98 escort would be plug and play, as in same loom used on both tacho and non tacho ones ?
tabetha

 

I thought that to. But its not much to my dismay.

 

Still cant get this to work.was told to wire it to edis module but there isnt one and was told pin 20 AND pin 2 on ecu. Which is it anybody know?

 

You need to identify the three wires going to the tacho on the rear of the clock set , these will be a live(ignition) a earth and a coil negative, from this you should be able to determine which wire is which and wire it.
tabetha