I have just brought a bailey breather and rocker cover for me car to try and stop it smoking so much.

But I am a little confused on how to fit it exaclty.

I know that the top 2 pipes go to the rocker cover and where the old breather fitted. The little bottom pipe goes to the lefthand side of the block and the bigger one vents to atmosphere.

but what goes here??

This pipe comes out the side of the old breather and goes into the plenum

Should there be a blanking screw to block it up

 

i screwed in a brass nipple and connected the carbon canister purge line back to it. once the factory brwtaher pipes are all off , u are left witha thin 6mm rubber one from teh purge solenoid at the bottom of the inner wing.

nipple seen here....

 

OR, if its not a green top one, just bung it witha plug

 

nice one mate

I thought it just needed a bung put in it, but wasn't sure

 

I was right max ps dont forget to bring the old cam cover round on weds, oh and that office 2000 disk