servo hose
#1
Regular Contributor
Thread Starter
Join Date: Dec 2007
Location: herts
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://passionford.com/forum/images/icons/icon1.gif)
i want to replace the rigid plastic hose from the servo to the inlet manifold. (the existing one has one of those crappy eko tec valves in it,screwed shut) will this silicone one be suitable.
its for a supercharged zetec mondeo.
http://cgi.ebay.co.uk/13mm-1-2-ID-Si...713.m153.l1262
or would i be better getting a length of servo hose. if so where?
its for a supercharged zetec mondeo.
http://cgi.ebay.co.uk/13mm-1-2-ID-Si...713.m153.l1262
or would i be better getting a length of servo hose. if so where?
#2
20K+ Super Poster.
![Default](https://passionford.com/forum/images/icons/icon1.gif)
NO, it is no good as servo hose as it will not withstand suction forces well.
Flexy servo pipe tends to be very thick walled, so it doesn't get sucked shut.
I would ring around pipe places, as it's nothing unusual as pipes go, maybe some OPA would do the job.
tabetha
Flexy servo pipe tends to be very thick walled, so it doesn't get sucked shut.
I would ring around pipe places, as it's nothing unusual as pipes go, maybe some OPA would do the job.
tabetha
Thread
Thread Starter
Forum
Replies
Last Post
Russ Payne
Ford Sierra/Sapphire/RS500 Cosworth
1
25-09-2015 08:29 PM