crankshaft thrust washers?
#2
PassionFord Regular
Join Date: Mar 2008
Location: Tipton Birmingham
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
I would alway carry out an end float check during build , just to make sure that they are the correct size , have known oversize thrusts to be fitted to a new engine , fit crank and use dti to make sure end float is within spec
#3
20K+ Super Poster.
The thrust part of the crank is not ground, but may be worn.
Always measure, if in doubt get new std size ones, as the tend to come slightly thicker than needed and you can then grind them down on a glass with grinding paste.
tabetha
Always measure, if in doubt get new std size ones, as the tend to come slightly thicker than needed and you can then grind them down on a glass with grinding paste.
tabetha
Thread
Thread Starter
Forum
Replies
Last Post
155lee
Ford RS Turbo Parts for Sale
4
06-09-2016 11:10 AM
155lee
Ford RS Turbo Parts for Sale
20
24-10-2015 11:11 AM
DavidK
Ford Sierra/Sapphire/RS500 Cosworth
1
27-09-2015 02:55 PM