My door wont shut on my series 1. Could it be the catch and if so what catches are the same. Series 2 or xr3i or standard mk3 cheers any help appreciated

 

u have prob flicked the catch by mistake if u go to the catch and flick it back the opposite way the door will close again

 

Nope its not that it doesnt stay if you flick it closed with the door open like the other side. is my catch broken and which ones fit (series 1 custom with c/l) cheers

 

if its the catch thats gone any mk3 catch should fit, but just the catch and use your oen lock and linkages m8 HTH

 

I did this to my sierra when fitting a new door. While adjusting the height ofthe door I slammed it and snapped the plastic plate in the catch area. It then wouldnt shut and when I looked I found I had snapped part off.

I had a spare door so took the catch mechanism out and put that in and didnt slam it so hard until the height was right after! Was a bit fidly to switch but cured the problem.

Hope it helps

Cheers