YB Spigot Bearing.
#1
Thread Starter
I've found that life I needed.. It's HERE!!
Joined: Aug 2003
Posts: 1,223
Likes: 0
From: Northwest
YB Spigot Bearing.
How far do I tap it in ? i.e. flush with the end face on the crank or up to the step in the bore that stops it going any further ?
Please don’t just post the link to the manual as I did have that, but since work upgraded my PC I don’t have it anymore and they won’t let me download pdf’s
Cheers for any replies.
WD
Please don’t just post the link to the manual as I did have that, but since work upgraded my PC I don’t have it anymore and they won’t let me download pdf’s
Cheers for any replies.
WD
#3
Thread Starter
I've found that life I needed.. It's HERE!!
Joined: Aug 2003
Posts: 1,223
Likes: 0
From: Northwest
Thats the problem, the bore in the crank (after the taper but before the stop) is about 4 to 5 mm longer than the bearing. I am not sure if I should go flush with the outside face or right up to the step
#6
Thread Starter
I've found that life I needed.. It's HERE!!
Joined: Aug 2003
Posts: 1,223
Likes: 0
From: Northwest
Thank you
I would have used the old one but it was completely mangled by the time it came out
Still no excuse though for not mesuring how far it was in though before destroying it
I would have used the old one but it was completely mangled by the time it came out
Still no excuse though for not mesuring how far it was in though before destroying it
Thread
Thread Starter
Forum
Replies
Last Post
STeve
Alloy wheels and ICE for sale
14
26-09-2015 05:40 AM
abdr500
General Car Related Discussion.
12
04-04-2005 06:45 AM