What map sensor do I use for my OFAB ecu if I wanted to run a stage 2 chip and different injectors? running say 14-15 psi for example, 2.5 or 3.0 bar

cheers

mart

 

3 bar

 

Its normally a 2bar. Fitting a 3 bar would melt teh engine on one mapped for a 2bar.

Ultimately, only the mapper of the chip will be able to tell you. However, all good chips come with full fitting instructions anyway. have you read them?

 

OK then what would you recommend as a package? I Have my engine being built at the moment. It is a 2.1 ZT fitted with arias pistons (7.4:1 C/R) on std rods.

I was hoping to run it on 2 bar, but at the moment i am stuck on chip needed, injector spec (using endfeed injectors) and what sort of map sensor I need to match the lot up.

any advice accepted

cheers

mart

 

Your ONLY acceptable and safe option is a full live map on that spec with OFAB mate.

 

Stu........tell me to shut up if im wrong but surely you mean fitting a 3 bar on a car mapped for 2 bar (or vice versa)would melt the engine.

 

Yes mate... Im a moron and have edited appropriately... lol

 

Well i did wonder whether to question it incase i looked silly

Ah well

 

 

I should really start copying/pasting some of those owned pictures