I need to get more informations about this pectel board. All I know is that it is a pectel board with a mountune chip for an escos.

Here are the things written on the pectel board :

RAM/ROM P8 Issue NO1 PCS

And then for the IC2 and IC3 eproms :

PEEL22CV10AP,TL21111,230FB

And finally the principal eprom :

IC1:P8C GPN4 2-5 bars MTUNE

I need to know for example if the pectel board can support als, water injection and such features...

Thanks very much in advance !

 

I too needed some info on my mountune chip and pectel board in my escos, here is a picture off it. I have spoken by e mail to a chap called anthony from mount tune and he gave me some good advice you can contact him as well his address is www.mountune.co.uk and look up contacts hope this helps.

 

i'd say at a guess..

P8 ecu, Grp N spec, using std 2.5 bar map sensor... which will probably not be very nice to drive on the road...