hi people ive just signed up so thought id post pic of me rs. bought it with clutch gone and few bodges.
[/IMG]
i have put 4 paddle ap clutch kit in esrt gear box bk in, escort cosworth alloys with 195/40/16 tyres, new rear light seals, new exhaust gasket with zetec stud n nuts, also ive converted the wheel hubs to take studs and not the bolts.

 

 

Looks real nice pal!
Wats ya plans with it??

 

It need new arch n sill on drivers side so will get them done.
I'm in stages of fitting cosworth management to the engine n try to get my other halfs dad to leather my seats n door cards. I'm after set of front brakes too 300mm 4 or 6 pots.

 

Has that been cut and shut between an early Rosso red ESRT and a late Radiant Red ERST?

Or is it just your camera?

 

The front end defo looks brighter.

Lovin the escos wheels on it.

 

The rear quarter n door is darker n rest of car is bright red lol will be sorting that when I get all arches done. Can people who read this post us, pics of there cars I'm just looking for few ideas. I'll get sum more pics up tomorrow of mine

 

I would be mines in a bit of a state at the mo plus it looks fairly standard anyways

 

few more pics





the holes in the front bumper was already there when i bought the car shame to mess up a good bumper.

 

focus st170 discs any mk3 mondeo front calipers 300mm brakes cheap and good

 

I have st170 front set up but was looking for sum 4 pots

 

looks like a good one you got there what plans you got for it

 

Need inner n outer arches. Cosworth management. Respary and leather re trim.

 

welcome to the site ,couple of pics of mine for you

 

Wicked car fella what u done to rear bumper. N love the seats

 

that is a well nice car man

 

I have cut in a section of bmw e46 sport rear bumper, and modified the diffuser and had it made in carbon fibre,also has vw polo number plate lights fitted aswell that sit flush

 

front bumper looks cool too all round its a minter mate. give me a few ideas for mine

 

Looks really nice on them wheels mate

 

few bits ive had aqua bead blasted









will be cracking on with rebuilding my head next week.

 

looking very nice

 

thanks mate need find sum place that can alloy weld to do my inlet n crossover for cosworth management

 

started striping engine down today and cleaning ready for the new management and head.
I cant believe some one can bodge a car so much and it still run list of sum bit I found
dowels missing from block to locate head.
washers missing from head bolts.
missing bolts from bell housing and starter motor

heres few pics on strip down n clean up

 

half way there now. bottom set up is done, head is off being ported n new guides fitted.
waiting on gaskets n bits but soon as they cum I can bolt engine bk together n make start on loom.







what u think bout the red EFI

 

Coming along nicely scott

What you use to paint the manifold?

 

thanks I was given a primer by a friend that good for alloy n just gloss black paint. ill find out what primer is