Antony.

I have done a lot of searching on this one and get a lot of conflicting answers and opinions on what i should be doing. I'm almost ready bolt my black top zetec upto a type 9 box with RS2000 bellhousing to be dropped in an escort. Buuuuut what clutch and flywheel?! I have heard of using a 1.8 zetec, 1.8 CVH and 2.0 zetec flywheel i believe that the pinto clutch can be used with the CVH flywheel but some adaption is needed? Would the flywheel need rebalancing once it had been redrilled. I'm also confused about which thrust bearing is needed, transit and capri i have read. I believe that one combination leaves very little pedal travel which would be a bit of a ball ache as i plan to use the escort daily-ish. It's all as clear as mud to me so any help would be appreciated. Thanks!

cjay2004

hi mate , u cant use a 1.8 cvh flywheel because theres no crank sencor pick up on it...
1.8 zetec is lighter then 2.0
the best way is to buy a 1.8 zetec flywheel redrilled for pinto clutch or have a machine shop redrill a 1.8 zetec flywheel 4 ya ?

stucapri2.9iTT

hope this helps
http://www.retro-ford.co.uk/shop/con...-flywheel-z015

stu

nuttynil

iTrader: (3)

A nice lightened 1.8 flywheel redrilled for a pinto clutch .an hydraulic clutch is good there is a good fix on one of the forums in will try and find it for you.

IanC

I used a 1.8 Zetec fly and pressure plate with a 1.8 cvh friction plate when I put a Zetec in a westie

Antony.

Hey guys. That's cleared it up! Thanks a lot.