(COLEYST200) focus to focos / skyline gear box
#415
PassionFord Post Whore!!
iTrader: (3)
Thanks mate i no were im getting the cage from just got to get the ŁŁŁ togever when i get back from CYPRUS Rex has had a chat with a welding company we use about welding it in after i tack it in and they have said they will do a cash job for me and come to my house and weld it here in the garage as they have a van kitted out
#416
PassionFord Post Whore!!
iTrader: (3)
Not done much today as when i got time to do some it pist it down
Any way in the week i had Dave round for a bit of help as things were not going well with the moking up but 2 hours later it was all on and we had good gaps on the doors wings and the bonnet all the stuff will be going in the bin as the doors are rotten and the wings all so . The bonnet is OK any way its all coverd up now for two weeks as we go on holiday tomorrow
And a BIG THANKS to Dave/whizzisat114 for your help mate
Any way in the week i had Dave round for a bit of help as things were not going well with the moking up but 2 hours later it was all on and we had good gaps on the doors wings and the bonnet all the stuff will be going in the bin as the doors are rotten and the wings all so . The bonnet is OK any way its all coverd up now for two weeks as we go on holiday tomorrow
And a BIG THANKS to Dave/whizzisat114 for your help mate
Last edited by COLEYST200; 18-09-2010 at 08:35 PM.
#418
PassionFord Post Troll
Like the wiper mechanism idea! but is it me or is the drivers side wiper now in a lower postition ? will the plastic scuttle panel fit ok over the top?
#420
PassionFord Post Whore!!
iTrader: (3)
It should all be ok as its bolted in the same place all i did pull the shafts out that the wipers arm gose on to and turn them over 180 degrees there is a small bit of moding that has to be done but no of if should ulter were it comes out of the plastic scuttle panel
#432
PassionFord Post Whore!!
iTrader: (3)
Iv started welding in the brackits in for the intercooler and rad i have had some advice of some lads and im not putting them were every one else i made my mind up and im pushing it forward and im very happy with were it is now i no the standard pipes will not fit straight on but thats not hard to sort out so it were i wont it now and im happy .
And thanks to Dave for the loan of the intercooler and rad and for making the brackets for me
And thanks to Dave for the loan of the intercooler and rad and for making the brackets for me
Last edited by COLEYST200; 09-10-2010 at 07:21 PM.
#439
PassionFord Post Whore!!
iTrader: (3)
Iv been have a play tonight and this is wot iv been doing
First off i got 2. blanks of ally
First job flash one side up
Then after a bit of work i came up with this i still have one more to do then do the inside to fit the bearing
Iv all so been getting some bits togever for my bilstein 909 rear shocks . A Big thanks to Tony at TCS for sorting some of the parts for me
First off i got 2. blanks of ally
First job flash one side up
Then after a bit of work i came up with this i still have one more to do then do the inside to fit the bearing
Iv all so been getting some bits togever for my bilstein 909 rear shocks . A Big thanks to Tony at TCS for sorting some of the parts for me