When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
your not hanging about are you mate you have got a lot done in the 2 weeks iv been away . and wot i love about these focus cosworth shell no 2 are the same
i iv boxed the front bosses in ,as i find with a cossie bonnet sat on the other one they get a tiny bit water in ,ow and the bootfloor will be different
jason mk2 colour that i think good choice tho ,as ther wount be one that
colour
as im only doing boiler services this week that don't take long ,means i been spending time in the garage
front rear turrets are in as is the diff mount ,every thing still to dress up but fort id
show im not hiding out ,waiting find out bout a bootfloor probly be weekednd by time i get out sorted
wiper motor/arms will need moding but probly do it as i got 2 for me own to do
got mate dinsy fold me this on press 5mm bit over kill but all he had in ,plus be easy drill an tap for a anti roll bar if he wants
its ready drop off the jig and clean up now still quit bit to do tho
looking good mate , what sorta price do you charge to do this
cheers lads
im not doing anymore after this one unless i get good wedge cash
as iv got some quarters to put on ricks focos but nowts sorted with him yet.
+ iv got one forsale and it wount sell if i build anymore lol
did the mods to jasons for the wiper motor this afternoon ,also been cleaning welds the worse bit ,managed to order the bootfloor also,
you can see the nicks i made with grinder as there to much grease an bearings use my
blow torch to heat it as its just for plumbing so to big of a flame
still weld up
jason you got bita rust to clean down
ian had the wiper motor mod idear good one servo fits a treat
Looking good mate . Have you cut some out of the arm that bolt on to the motor as i hot wired my wiper motor and it had to much throw on it after i had done the mod on my shell .
Looking good mate . Have you cut some out of the arm that bolt on to the motor as i hot wired my wiper motor and it had to much throw on it after i had done the mod on my shell .
not tryed it yet mate will try it on the other shell that got a screen in
seemd ok in the vise but will tell better on the car i guess
Fuck me Andy you dont mess about do ya top fab work
Have you welded in nuts for the diff to bolt too? or tapped the holes?
cheers pal ,not welded any nuts yet really needs the running gear and diff hanger bolting in but there plate on top weld some nuts to ,kinda like on the other shell
well thanks to beefy i got the seat mounts in and done also car droped off jig for last time ,its all go with the cleaning up of welds now ,still the colume and dash surport to do when jason picks the shell up at a later date
could done with coilovers to fit up really as that what is set up for
did you tack the left one together or u get it sorted ?
just used a tape measure beefy as the front mounts were already in the rite place ,there is always room to widen the holes if need be pal when a full seat put in