First Project, Escort 1300, Finished! 6/10
#85
15000
Join Date: Apr 2008
Location: Cambridgeshire & Lincolnshire
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Hello, thanks for your comment, I saw your post before I signed up, good luck on the project looks like you've got your hands full!
Ignore the comments about the colour etc theres loads of potential there... Your head looks wicked I may have to go about it on mine as i've just discovered a load of old oil all over mine!
If RS200 or GTI bits are too expensive you wanna look at some SI bits if you can find them, theres loads kicking around on ebay at the moment, let me know how you get on
Ignore the comments about the colour etc theres loads of potential there... Your head looks wicked I may have to go about it on mine as i've just discovered a load of old oil all over mine!
If RS200 or GTI bits are too expensive you wanna look at some SI bits if you can find them, theres loads kicking around on ebay at the moment, let me know how you get on
#88
Shizzle My Nizzle
iTrader: (1)
Join Date: Aug 2006
Location: ESSEX
Posts: 3,755
Likes: 0
Received 0 Likes
on
0 Posts
hey mate heres that pic of my old 1.3 escort with the springs off of it that you bought from me.
as said all i did was springs, 17" 100+wheels, painted front and rear bumpers, added a gti spoiler. remover front grille, and washed and waxed once a week!!
as said all i did was springs, 17" 100+wheels, painted front and rear bumpers, added a gti spoiler. remover front grille, and washed and waxed once a week!!
Last edited by Lee Ivatt; 30-04-2008 at 01:22 PM.
#89
I actually Bum This Place
Join Date: Jun 2007
Location: Swadlincote (Near Derby)
Posts: 1,481
Likes: 0
Received 0 Likes
on
0 Posts
that looks tidy as that does! I'm looking into an escort as a first car as im 17 in july
#92
Too many posts.. I need a life!!
Thread Starter
Join Date: Jul 2007
Location: Birmingham
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
Been a while since i last posted on here.
Havent had time to do much as ive been busy with college and stuff.
anyway i took the engine out last weekend. Was gonna clean and paint it. The clutch is worn too. going to clean the engine bay while its out.
Havent had time to do much as ive been busy with college and stuff.
anyway i took the engine out last weekend. Was gonna clean and paint it. The clutch is worn too. going to clean the engine bay while its out.
#96
Too many posts.. I need a life!!
Thread Starter
Join Date: Jul 2007
Location: Birmingham
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
#97
Chief Iron Oxide Farmer.
Join Date: Apr 2008
Location: Portland
Posts: 1,319
Likes: 0
Received 0 Likes
on
0 Posts
Looks good.
The engine is almost identical to my 1.3 HCS - apart from that strange tubing across the manifold and the copper pipe behind your plugs.. What does all that do?
If its an emissions thingamebob would you gain power by binning it off?
The engine is almost identical to my 1.3 HCS - apart from that strange tubing across the manifold and the copper pipe behind your plugs.. What does all that do?
If its an emissions thingamebob would you gain power by binning it off?
#99
Too many posts.. I need a life!!
Thread Starter
Join Date: Jul 2007
Location: Birmingham
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
Wont it cause higher emissions if i remove it?. not sure how to block the four ports it connects to on the head.
Painted the other side and cleaned up the coil pack
Painted the other side and cleaned up the coil pack
#114
Too many posts.. I need a life!!
Thread Starter
Join Date: Jul 2007
Location: Birmingham
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts