gaz_turbo1

UPDATE AT BOTTOM OF PAGE

been looking on here for a while now and thought i would put a few pics of my project i am doing at the minute,
bought a 4wd starlet of ebay for 640 quid with plans to strip it all back and make it a gt replica but going fully forged and 1.5 block and using the td05 i have
i swapped my white gt which was td04 lsd etc with a mate for his not so good looking gt



then started stripping and swapping everything over





engine out



dash and loom out of car






gearbox all cleaned down and painted

front bumper all cut out

5efe engine


inlet given a quick clean up

engine bay rubbed down and sprayed black


bit more work done today, complete loom swapped over, steering rack, brake servo, master cylinder, clutch cyclinder, pedals all conected back up, steering coloum swapped over, fuel lines had to be cut and joined as the gt has different fuel filter connector, brake lines put in, gt calipers, disc and stering rack fitted to hub and wishbone, heater and air con all removed fron inside dash, as the wiring is different, power steering fitted




the colour i am after



dash and complete loom in and working


got a few pics and parts, BIG intercooler 34 inch wide, front and rear anti roll bar's will have to modify the back one to fit as the diff is in the way, trd engine mounts, toby's catch can, apexi avcr, loads of intercooler piping, anyone got any links on wiring in the avcr







got 5e engine completely stripped down and done a few more photoshop's






cleaned and polished out the head too

















carpet been taken out and floor all primed up and resprayed black, and I have ordered TURBO:rockon:




this the turbo i pick up on monday .63 hot side and the 4" anti suge

MAD EVO 4

Looks like you have got yourself a good project

jameswrx

Interesting project, my mrs had a starlet gt and now a glanza.

What's the 4wd system strength like then? 400bhp should be a fair test for it

Good luck

gaz_turbo1

no one really tested out what it can take but will find out , can see it blowing into a million pieces 1st launch LOL

Spiky

iTrader: (1)

awesome proect


can i ask, your gearbox,

what did you use to clean??
how did you paint it?
any under coat???



can you give me a quick run down on painting it please

gaz_turbo1

gave it a quick blast with pressure washer then some degreaser then blacst it again then used hammerite smooth, painted it on with brush

Spiky

iTrader: (1)

ok cheers dude

thanks for that

Dan

Great little project mate! Good work so far, keep it up!

Red16

not very often you see a starlet on the roads, cool little cars... this ones gonna be a wee bit better

fezzajsy

iTrader: (9)

should be a wee beast when done

gaz_turbo1

yeah should be fairly quick when done ,

gaz_turbo1

picked up new turbo from cr turbo's is a t3-60-1 witha .48 hot side,

Twins

iTrader: (18)

Nice project there ,slight turbo upgrade 22b in the pic is my mates one

gaz_turbo1

yeah that 22b was one of the nicest car at the show, did he run that day?

gaz_turbo1

teaser pic, only place it would fit

fezzajsy

iTrader: (9)

come along nicely

yardy2186

dont feel too bad about the drive system as is is 4wd or is it awd?
the difference is 4wd is not always on( like skylines GTR'S) while awd is always activated ( like evos)
honda make a 4wd wagon version of their civic that comes with less than 130hp and even though a lot of people slated it it has been used on honda D16s producing around 400hp
here is the link:http://www.honda-tech.com/zerothread?id=2104408&page=1
plus there are videos that show how it hooks up on launch
also for the avcr wiring go here http://apexi-usa.com/support_wiring.asp
but people have issues setting up gear based boost even using the manual
so go here for that http://www.honda-tech.com/zerothread?id=1037051
hope that helps mate

gaz_turbo1

got car back from bodyshop. smoothed in petrol cap.airiel (sp) and rear boot lock and wiper
and picked up a few other little bit's external fuel pump, air filter and wastegate










wastegate and external fuel pump

Bomber

I use the same Turbo as you (also with a .48 housing, AVC-R and Tial 38mm) - watch out for compressor surge. Great project!

Chip

iTrader: (3)

Awesome project

gaz_turbo1

cool, what engine do you have it fitted too, and what power you making and when are you getting full boost?

fezzajsy

iTrader: (9)

looking good

gaz_turbo1

cheers people

Fiesta_ie

you will make look m3 look like sily cars

Mr.T

Nice project you have there. Love the turbo upgrade

_DAN_

Cool lil project.

Didn't know they done 4wd Starlets....

gaz_turbo1

a 250bhp starlet would make a m3 silly, let alone 400

yeah it not a turbo starlet but same chassis-body etc

cheers

Daveysaff

iTrader: (9)

A mate of mine did a 230bhp 1.3 starlet in ST orange last year and that was quick as fook!! This is going to be immense

Sticky.

iTrader: (4)

Cool project

woolford

very good project

crazyshad1

nice project, will suprise alot of super cars

gaz_turbo1

bit more progress








whats better than one forged 5e engine, two forged 5e engine's

Stavros

How strong is the 4wd setup?

Starlet turbos are awesome cars

p17fld

Quality project, love the colour

gaz_turbo1

don't no how strong it is, but pose to be one in eirope running over 300, and couple in NI with over 200,

gaz_turbo1

bit more of an update, just need's suspension and all oils put in and were off

Rab

How cool is that!

Charlie Chalk

iTrader: (1)

cool, not long by the look of it

Turbo Zetec

iTrader: (1)

we need vids

Crowder

sleeper