Adam_BlackRS

Damn you Paul Eggleton What the hell did you do em up with ?

Anyone got any tip/hints for getting them un-done ?

B19-TRB

U turning em the right way!?

Adam_BlackRS

I think so

Lefty loosey, righty tighty ...... or are one direction depending on what side its on ?

B19-TRB

I think 1 of em was a left hand thread!

Paul Eggleton

Dude, I never touched them. Which is why you probably can't get them off

As Lewis said one of them is left handed. Don't know which

If its any consolation I can't get the ones off the cossy. I've broken two square drive adaptors

Adam_BlackRS

So, left side would have to undo by turning right if its the left hand thread ? and right side would have to undo by turning left as a normal thread ?

I'm confused

B19-TRB

Just go get a fook off big breaker bar! or a bit of scaffold tube on the end of ya rasheeeed!

Micky The Finn

the one with little notches in the nut is left hand thread,tighten to loosen if you get what i mean.

B19-TRB

righty loosey, lefty tighty!

zvhturbo

Both need to be turned to the left on a ERST to undo

Get someone to hold the brake pedal down hard while you get a big torque rench on them

Adam_BlackRS

Just tried it again, with big bar......nothing, not even moving a bit. It been soaked in WD40 but hasn't made a difference.

Time for some heat