Got mine the other day, what size drill bit should i use to drill out the hubs??

 

 

Boing

 

measure the outside dia of the bolt, and minus 1 to 2 mm.

 

The shank measurement of the stud is 13.1mm. I think I used 12.9mm, but might have been 12.7mm.

I will go see if I can find the Drill bit.

 

If your drilling then tapping the hub, you drill to the the size of the stud on the dia, minus the depth of the thread, i.e.

M20 bolt has a 2.5mm pitch, which has a 1.5mm deep thread, so you use a 17mm drill. If that makes sense.

 

Christian and Beccy, Thanks mate, knowing my luck - i'd drill the hole and the stud would fall out

churchy, No tapping needed mate. I was in your neck of the woods last weekend - Caister Soul Weekender at the Vauxhall Holiday Park

 

From memory, I bought 12.7 and 12.9 to be safe. Might be worth doing that and trying the 12.7 first.

 

I livr right next door the the camp, I throw all my rubbish at the caravans the other side of the fence
Should have taken a walk towards the centurian pub and turned off down a little path on the same side of the road, head towards the beach and you'd have found me

 

Probably a good thing that he didn't.

 

Wait till I see you Christian Which will be soon cause its almost due a service

 

churchy, He was pissed most of the time he was there don't think he would have remembered!!!!

 

"Thank you for calling APT, Im afraid there's nobody here but us Chickens, please call back later......Beeeeeeeeeeeeeeep"

 

Cheers all

Maybe next time churchy,

 

AnnA, thats why everyone from Caister are alcoholic stoners, Fook all entertainment.

Christian - I know where you live