Mattus1000

Hi all,

just wondered what you thought of my mapping results today?

2wd cossie in rwd fiesta
650cc injectors
Bosch 044 pump
4x4 intercooler
Turbo technics s112 stage 3 turbo (t34 0.55 housing)
3.5 bar map sensor
Standard internals
Running 1.6 bar boost (turbo is good for 2 bar if pushed)

Being that I dont really understand graphs and havent collected car yet, looks like 352bhp and 342ft lbs of torque unless I am reading it wrong?

Mad_Mat

Hi looks good to me. I have same turbo TT S112 with a few other mods and made 362/345 on Dyno dynamics at MSD at 1.5bar.

Mattus1000

Ahh very similar then! I have been told the graph actually shows 380ft lb of torque which I'm pleased about. The mapper said that he was unable to increase the preload from the actuator, did MSD go quite conservative on yours rather than maxing the turbo as I thought they were good for 2 bar and 400bhp?

Thanks for your help

Matt

Mad_Mat

When i had it mapped i was hoping for near 400 but i am running bosch light blues 440cc and fuel was becoming an issue. It really wants a set of greys in it. Mine is setup and mapped lovely now on the blues so been reluctant to change it before i make the car stop and handle as i want.
This TT turbo and 2 bar imo would see 380-400 on a healthy engine, spec depending. I'm sure the dinosaurs on this forum would agree.

Mad_Mat

my graph for comparison.