Hi folks, got a couple questions I hope someone can help with.

Dropped a knackered engine off to be stripped and rebuilt last week and got the dreaded phonecall today saying the crank cannot be saved

I think I have sourced a crank and everything else is ok apart from the rod on cylinder 4.

Looks like I will have to buy a complete set so what would people recommend??

It won't be chasing big power, stage 3 on a t34 is as far as it will be going.

As said everything else is fine....pistons, bores, head etc, just need some advice on rods to go with the crank.

Thanks in advance

 

standard rods are great in a yb, they are good for circa 600hp so no need to change.

 

If you want to get uprated then PEC but i would stick with standard

 

Cheers, standard it is then.

Any idea where stocks them? Can find one set on ebay and that's it

 

try burton power maybe

 

Burton only list Farndon rods for them nowadays

 

I have several rods I will sell singularly if required.

I also have a reground crank too

 

Pm'd markk

 

second hand bud, just get everything checked and balanced beforehand

 

Yep I don't mind using used parts as long as they are good. The engine is all stripped and will be rebuilt by a pro so no worries there