does anyone have a part number for a injector that is HIGH impedance, and still fits the standard fuel rail setup? upto 350-400hp ish?

Im running emerald management so cant use Bosch Low injectors.

Siemans Deka's will do, but not sure on Part no.s.

Thanks!

 

You could try a set of injectors off a Fiat coupč 16v turbo, they're made by Weber, are around 385cc disc type and are high imp. around 13.9 Ohm at room temp.
I used them for ages on my 2.0 16v mill without issue.

 

They won't do anything like 350 bhp though!

 

guys, same problem.

I need high impedance injector for cossie...

400cc (ideal),..

are there any with direct fit?

 

There are hundreds. Cossie just uses a bog standard Bosch style fitment, 14mm o-rings etc.

They are without doubt the most common fitment. Old BMW,s Volvos, Fords, everything used to use that fitment.

 

I use these 630cc ones on my MG ZR with Pectel T2 management, they will also fit directly into a Cosworth with no mods as I used the higher capacity model on my RS500. http://www.siemensdeka.com/product/6...fi114961-60mm/

 

http://sasautocustoms.co.uk/bosch-pe...2lb-465cc.html

 

Have you used those Mark? I was tempted by them for my LS2 Chevy but found contradicting specs for them. The site below has them listed at 29lb/hr @ 3 bar


http://www.gomog.com/allmorgan/InjectorRatesBosch.html

 

Yes I have used them on 800bhp thread on here. 8 of them on a 500hp engine work very well.

Mark

 

Thanks for the info

 

Great injector, proven the world over thousands of times.

I've 16 of them lol