STUCOS

iTrader: (8)

Help just about to torque down a yb head with long studs,and cant find my book with all the torque settings in,so can somebody help asap


cheeRS stu

bad boy rs

iTrader: (7)

did mine last weekend although without the long studs, 50lbs then 90 degres and 90 degres again

STUCOS

iTrader: (8)

Cheers bud,but long studs are diffrent

cheeRS stu

bad boy rs

iTrader: (7)

thought so, good luck

vroooom ptssssh

I can't remember for certain but it's likely 86ft/lb with the moly lube!

andy130

iTrader: (2)

stu are you on ecort cosworth site? pm me mike he should no?

KSA-Cossie

iTrader: (4)

Bump,let me know when its done stu as im dropping the car off tomorrow at 9

Toe Knee

iTrader: (2)

the studs themselves or the nuts?!

The studs on mine i did 50-60lbft

the nuts i did too 30lbft, 60lbft then 90lbft and checked the next day to make sure they were still 90!!

STUCOS

iTrader: (8)

Kev all done,waiting on being collected,just needs your man to fit manifolds and belt/pulleys

cheeRS stu

rstoughy

iTrader: (5)

Stu,

What was the answer on this??

Have my Head and new Gasket sitting just ready to go on so need the torque settings.

6 studs with 4 layer Mountune Gasket.

Now do i use old used strech bolts or new ones for the 4 corners

Toe Knee

iTrader: (2)

What i said i did on mine mate and havnt had a problem yet with it!! Got the settings off Tabs on here, and theres a post somewhere saying the same setting too!!