3 bar map sensor
#1
PassionFord Regular
Thread Starter
Join Date: Jul 2006
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
3 bar map sensor
Evening all ive done the usual and broken the nipple off mine for the 4th time and think its beyond repair now! was wondering if anyone had tried one of the copied ones off ebay? and if anyone knows who makes them? also if anyone has an idea if the internals are the same as the genuine units? as they are half the cost, are they half the spec as i dont really fancy rebuilding my engine again just yet!!!!!
#3
PassionFord Regular
Thread Starter
Join Date: Jul 2006
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
James while im inclined to agree i feel your opion is slightly bias! as you sell these!! lol and the companies selling them dont seem to have any negative feedback about them. it was just a general question really.
#4
Passion for Fords!
iTrader: (13)
not bias at all.
if they were any good we would sell them instead lol
i know of several failures and have replaced a few during mapping as we found them inaccurate. as most chinese imported stuff is
ps, you say yours is now beyond repair surely you havent repaired it before thats dead engine material
if they were any good we would sell them instead lol
i know of several failures and have replaced a few during mapping as we found them inaccurate. as most chinese imported stuff is
ps, you say yours is now beyond repair surely you havent repaired it before thats dead engine material
Last edited by JTECH James; 18-01-2010 at 09:04 PM.
#5
PassionFord Post Troll
how do you keep snapping it?
if its cos you taking engine out. just remove vac pipe from inlet and leave attached to map sensor, thats what i do.
if its cos you taking engine out. just remove vac pipe from inlet and leave attached to map sensor, thats what i do.
#6
PassionFord Regular
Thread Starter
Join Date: Jul 2006
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
and yes removing the vac pipe is the best idea.
looks like a new unit it is then MR LEWIS im coming to get you. lol
Trending Topics
#9
PassionFord Regular
Thread Starter
Join Date: Jul 2006
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
#10
20K+ Super Poster.
As said well worth the money for genuine one, in comparison to engine cost.
Never seen a copy one on a cossie, but on another car it(copy) was all over the place, and so of course was the fuelling, maybe put some nice soft silicone vac pipe on so not as much strain if you do accidentally hit pipe.
tabetha
Never seen a copy one on a cossie, but on another car it(copy) was all over the place, and so of course was the fuelling, maybe put some nice soft silicone vac pipe on so not as much strain if you do accidentally hit pipe.
tabetha
Thread
Thread Starter
Forum
Replies
Last Post