Heathen

I need to remove and replace the pillar moulding between the front and back window.

The bit where the seatbelt height adjuster is.

I've got the two screws out, but I just can't get it out from there...

Please and thank you.

Heathen

Sorry for the shameless bump.

I just really need to get this done quickly.

*BampF*

mechanic28

iTrader: (5)

sorry mate never done one but a free bump for ya anyhow

johnandhissaffy

iTrader: (1)

try popping it off it might have clips on it to hold it in if not look for caps on the moldings and pop them out to see if there's any other bolts or screws good luck

Heathen

Yeah, i've got the moulding free (just two screws), but it's the sliding mechanism that the seatbelt goes through that is holding everything back.

Good idea about the clips though...i'll see if there are any holding the sliding part on.

Thanks fer the bump, Mechanic! Haha

johnandhissaffy

iTrader: (1)

move the slide bit to see if there's bolts behind that if not just look around

that's k mate

neil andeRSon

iTrader: (3)

pop the middle bit out with the arrow's on it from the top. there's 2 screw's in behind.